Industry Schools FE/HE Site: Industry Site: Schools Site: FE/HE Site: Mobile
 +44 (0)1206 751166  

SCI TA101A1 Miniature Toggle Switch SPST On-Off

Order Code:

75-0125

Brand: SCI MPN: TA101A1
 Report an error
Qty Ex Vat**
5+ £0.700
25+ £0.640
100+ £0.590

Get a quote for large quantities here

**Price per unit
MOQ is 5 Sold in multiples of 5
747 In Stock
Same day despatch

Buy Miniature Toggle Switch SPST On-Off from SCI – a low cost panel mounting miniature toggle switch.

  • Provides exceptional value
  • Fully approved to UL and CSA
  • Manufacturer's part TA101A1

Contact rating6A, 125V, 3A 250V AC
Initial contact resistance<20mΩ
Insulation resistance>100MΩ at 500V DC
Contact materialCopper alloy with silver inlay silver plated
Body materialFlame retardant alkyd
Electrical life>1 x 104 cycles at full load (min.)
Operating temperature–20°C to +65°C


30 October 2017 Question by: Steve Vermaak | Product code: 75-0125
Q. Can these switches be used with a 9v battery and leds???? As I use 75-0082 to run my lamps on a 9v battery
A. Hi Steve, thank you for your question. Yes these switches can be used with a 9V battery.


10 July 2017 Question by: Colin Singleton | Product code: 75-0125
Q. can this be used ith a 12v dc battery supply?
A. Hi Colin, thank you for your question. Yes this will work on 12V; 6 amps max rated.


17 July 2013 Question by: Jamie | Product code: 75-0125
Q. Hi Is this switch safe to use for a domestic lamp running off the mains? Many thanks
A. Hi Jamie. Thank you for your question. This switch is rated at 3 amps at 250V so as long as the bulb(s) total in watts is less than approximately 650W then this switch is suitable.


28 June 2013 Question by: eddie | Product code: 75-0125
Q. Hi does the minature toggle switch cover 75-0120 fit this?
A. Hi Eddie. Thank you for your question. Any of this range will fit this cover, starting at 75-0125.

Simple and effective

Reviewed by: Ariel - 17 January 2014
These switches do what they say. The only thing is to be careful about the hole you drill to stop the switch from rotating - the tab bit only goes into the bottom part of the hole, so it will be very visible. Otherwise this is fine.