The A 1532 EVSE XA adapter is used for verification of electrical safety and functional testing of EVSE together with supported METREL installation testers.
It is intended for testing Mode 3 EV supply equipment with a type 2 connector. XA version supports 3 phase load testing up to 13A and different error types, including PE open. If used together with Metrel AutoSequences®, prebuilt in the newer multifunctional testers, the complete EVSE charging station can be tested (state-by-state) electrically and functionally with a push of a button. It is possible to create a professional station-based report with MESM.
Key features:
- Banana socket outputs for connection to a 3-phase installation tester
- Voltage indicators on EVSE output
- Proximity Pilot resistance selector for simulation of EV cable presence and current rating detection
- Control Pilot resistance selector for simulation of electric vehicle status
- Socket output for connection to a 1-phase installation tester (Phase 1, Neutral, PE)
- Type 2 Male Plug connector for connection to EVSE
- 6 mA EV RCD support
- Functional tests support
- EVSE AUTO SEQUENCE® support
- MESM report creation
- Load testing up to 13 A on socket - 1 phase or on banana sockets - 3 phase
- Fault simulation of Diode short, PE-CP short and PE open
- Output BNC connector for CP signal monitoring
| Type |
EVSE Test equipment adaptor |
| Function |
l tests support |
| Height |
70mm |
| Insulation Test Voltage |
CAT I |
| Length |
250mm |
| Protection |
IP40 |
| Test Lead Length |
50cm |
| Testing Type |
EV |
| Width |
100mm |
To use this facility please Sign In.
Sign In
{{SessionBasket.ItemCount }}
