Pimoroni PIM271 Wider Input SHIM Kit 3-16V for Raspberry Pi

Get Pi power from 3 to 16V with a SHIM!

This Wide Input SHIM gives you the ability to use a range of different power supplies with you Raspberry Pi, including the ubiquitous 12V barrel jack power supplies. The super-slim design of the SHIM means you can solder it straight to your Pi's pins yet still use HATs and pHATs on top. The SHIM will provide a 5V 2A output (through the GPIO to the Pi) at input voltages of 5V to 16V. Current drops to 1.5A at 4V, and 1A at 3V.

For input voltages there is either a centre positive 3.5mm jack connector or two broken-out + and - pins on the SHIM. There is also a short male to female adaptor cable included so that you can use the common 5.5mm jacks too. Also included is a 3.5mm male to tinned wires cable, so you can attach it directly to, for example, a bench power supply, or to solder it into a project.

• Super-small SHIM-format board
• 0.8mm Thickness PCB
• Can be used with HATs and pHATs
• 3.5mm OD Barrel jack connector (centre positive)
• Adaptor cables included
• Output 5V 2A
• Input 3 to 16V
• Reverse voltage protection
• EN (enable) pin to switch off output voltage (pull to ground)
• Headers require soldering
• Dimensions 45 x 17 x 6mm

TPS63070 Buck-boost converter chip

Type	Wide input SHIM for Raspberry Pi
Compatible With	Raspberry Pi
Dimension	45 x 17 x 6mm
Dimensions	45 x 17 x 6mm
Head	rs require soldering
Input	3 to 16V
Output	5V 2A