Manufactured with a pressed steel outer casing, lighter than traditional models at 20kg. Inverter technology offers many advantages over traditional transformer type welders, giving greater duty cycles and more power factor efficiency. 3-in-1 Welder uses state-of-the-art technology to achieve MIG/TIG/MMA (Arc). Suitable for arc welding a variety of rods including rutile, basic and stainless. Fan cooled DC power supply for MIG and TIG, suitable to weld steel, stainless steel, copper, nickel, titanium and their alloys. Switchable between MIG, TIG* or MMA* welding modes (*optional extra torches required). Thermal overload protection which automatically switches off when it exceeds maximum temperature. Fully functional front panel with self explanatory pictograms for each dial and switch. Wire feed control for adjusting speed of wire fed through the torch during welding. Polarity change terminals allow for MIG or flux-cored welding. Includes 3m MIG torch, earth cable, gas hose, regulator and contact tips.
Model No
INVMIG200
Nett Weight:
17.4kg
Duty Cycle:
MIG:
20% @ 200A, 100% @ 90A
TIG:
20% @ 200A, 100% @ 90A
MMA (Arc):
20%@170A, 100%@76A
Wire Capacity:
5kg
Electrode Capacity:
Ø1.6-4mm
Absorbed Power:
6.64kW
Supply:
230V**
Insulation:
IP21S
Protection:
F
Weight:
20kg
MIG Torch:
Euro Non-Live BINZEL® MB15*
MMA Accessory Kit (Optional):
MMA01
TIG Accessory Kit (Optional):
TIG10S
Note:
*Included as standard, **To achieve maximum power a 32A supply may be required.
Q. Just put a new spool of wire on my welder and after a few minutes it stoped working the moter is not woring it's just clicking it started for a few sconds and stoped I have checked everything and still just a ealay clicking can you help med
A. Hi Dave, thank you for your question. According to the instruction manual if the correct groove size is not picked to match the wire size this can result in the wire slipping or not rolling, this is possible. Please see the instruction manual.
