Joy-It Gas Sensor

This analogueue gas sensor has a small heating element with an electronic-chemical sensor. It is suitable for indoor use. It can only output accurate measured values after the warm-up phase has been completed. It is compatible with all microcontrollers (an A/D converter is required for Raspberry). The sensor is characterized by its fast response time and its wide detection range. The sensitivity can be adjusted by a potentiometer located on the bottom of the module.

Height	22mm
Interfaces	Analogue
Internal ports	Pin header
Length	32mm
Max. operating voltage	5V
Tool type	Multi-sensor unit
Type	Detector
Width	20mm