Arduino Proto Kit Rev3 Includes Components A000083

The Arduino Proto Shield Kit is laid out with Arduino Rev. 3 compatible pads and labelling. Make the jump from breadboard to shield with its large prototype area, pads for SMD and through hole chips. The kit contains three LEDs (red, green, yellow), two tact switches, 5 x 10k Ohm 1/4W resistors, 5 x 220 Ohm 1/4W resistors, 5 x 1k Ohm 1/4W resistors and a strip of header pins. If you are still experimenting then its possible to mount a small breadboard neatly between the header pins on top.

• Arduino Rev. 3 header pin holes and labels
• SMD and DIP IC areas
• Large grid of solder pads
• Pads for ICSP connector
• Mounting holes pre-drilled

Type	Proto-interface