Aim-TTi PL601-P(G) Power Supply Single 0-60V/0-1.5A

The Aim-TTi PL601-P(G) achieves an exceptional power density for a linear regulated power supply by offering up to 90W from a ¼ rack 3U sized casing. This gives it an unusually small bench footprint taking up less space on a crowded bench. For rack-mount application, up to four units can be mounted into a single slot. This version is supplied with the GPIB interface.

Despite its small size and linear regulation, the Aim-TTi PL601-P(G) generates relatively little heat through the use of an advanced phase controlled pre-regulator. This gives it significantly higher energy efficiency than conventional linear regulated designs, particularly when supplying lower voltages.

The internal heat-sinks use fan-assisted convection cooling in order to remove the heat with minimal fan noise.

To meet the varying needs of todays engineers, the Aim-TTi PL601-P(G) has a comprehensive array of interfaces is provided. RS-232, USB and LAN (Ethernet) with LXI and GPIB support are provided as standard.

Each of the digital bus interfaces provides full control of voltage, current, and output on/off, plus read-back of voltage, current and status. The interfaces are at ground potential and are opto-isolated from the output terminals.

• High performance linear regulated power supplies
• Full digital remote control and readback
• RS-232, USB and LAN (Ethernet)
• LAN Interface conforms with LXI standard
• Interfaces are opto-isolated from outputs
• IVI Driver supplied
• Analog remote control of V and I
• Front and rear terminals
• Selectable remote sense terminals
• Ultra-compact size of quarter-rack 3U
• High power density - up to 90W per output
• Manual control features as per New PL Series
• Manufacturers part no. Aim-TTi PL601-P(G) GPIB
  

Not recommended for use as a battery charger.