The PICAXE-20M project board provides a rapid development system for the PICAXE-20M microcontroller. It provides the basic download circuit, connection points for inputs/outputs and an optional Darlington driver buffered output circuit.
| Type | Project board kit |
|---|
Q. Do you sell a 3xAA battery holder with flying leads? It seems a shame to connect a 9V battery snap and then a 3xAA one too.
A. We sell one with solder tags, https://www.rapidonline.com/3-x-battery-holder-aa-tags-18-0127. You would need to solder on wires
Q. It says on the data sheet that the board requires 3AA batteries not a 9V battery. So do i need to buy a 3 x AA battery holder here... https://www.rapidonline.com/Electrical-Power/Battery-holder-for-3-x-AA-Keystone-2464-18-3685 Kind regards
A. Hi Andrew. Thank you for your question. A battery holder is required: 18-0126 is a 3AA holder. If you use a 9V battery it will blow up the chip on the board.
Q. Does this starter kit include the 4.5v (3 AA) battery clip pack that it states to use in the data sheet?
A. Hi Andrew. Thank you for your question. This starter kit comes with a battery clip - we do not sell a battery clip pack.
