•  Change Product Range 

 +44 (0)1206 751166  

Welcome, to enhance your experience we have divided our site into the following sectors. Please choose the one most relevant to you and continue.

We use cookies to ensure that we give you the best experience on our website. If you continue without changing your settings, we'll assume that you are happy to receive all cookies on the Rapid website. However, if you would like to, you can change your cookie settings at any time.


PowerPax UK SW3346 36W Volt Adjustable Multi Output PSU

PowerPax UK
PowerPax UK

MPN : SW3346

You may also like
PowerPax UK SW3346 36W Volt Adjustable Multi Output PSU
Image Representative of range.

Order Code:



QtyEx Vat

In Stock
Despatched same day

This innovative plugtop switch mode power supply from PowerPax UK will supply any one of 20 fully regulated voltages by means of a resistor that pushes into the side of the unit.
  • Output voltage cannot be changed by mistake
  • Output voltage between 5V DC and 24V DC in 1V increments
  • Output current 3.8 to 1.5A depending on voltage
  • Supplied with UK, European, USA and Australian push-on input pins
  • Standard output connector pack includes six connector types
  • CB, CE, GS approved

Input voltage100 to 240V AC 50/60Hz
Output voltageOutput currentOutput voltageOutput current
Output connectors
Type A2.5mm maleType B3.5mm male
Type D2.1 x 5.5 x 12mm femaleType G2.5 x 5.5 x 12mm female
Type H1.3 x 3.5 x 10mm femaleType N1.5 x 5.5 x 12mm female

Question by Paul Gardner | Product code: 85-2908
17 January 2014

Q Does this have short-circuit or over-current protection?
A Hi Paul. Thank you for your question. We have spoken to PowerPax and they confirmed this power supply incorporates short circuit/over current protection.

Question by John | Product code: 85-2908
07 January 2013

Q Can I drive three 9 x 1 watt power led units i.e - 55-2612 (family) optimally with this power supply and would I need to wire them in series or each unit seperately from the power supply?
A Hi John. Thank you for your question. You can drive 2 but not 3. The voltage needs to be set at 12v. You can drive 2 from one supply with the led modules in parallel. I would suggest one supply per module as each draws 1.5A. With 2 the supply is at the max of 3A so it may not be the best solution for long term reliability.

Question by Kevin Dearling | Product code: 85-2908
12 November 2012

Q Hi, can you tell me if the the voltage supply is regulated? thanks, Kevin.
A Hi Kevin, Thanks for your question. The voltage supply is fully regulated.

v 3.0