Light switch with motion sensor PIR

review this product

Manufacturer : Timeguard
View all from this manufacturer

This switch with built-in PIR sensor, automatically detects motion and turns the light on, turning it off again after a time adjustable from 6 seconds to 12 minutes.

Auto On/Off selections
180° detection area with adjustable 8m detection range
Light ON times adjustable from 6 seconds to 12 minutes
Fully adjustable light level control
Suitable for lamp loads: 40-500W incandescent, 40-150W low voltage halogen, 18-150W fluorescent with electronic ballast, 15-150W electronic PL lamp (Philips or Osram only)
Can also be used as a normal On/Off switch (1-way only)
BSI and CE approved

Product details Hints & Tips

Description

Code

RoHS

Datasheets

Manufacturer Part #: ZV810

Light Switch with Pir

23-4912

£24.70

£23.14

In stock
despatch same day

Buy

Questions

Submit a Question

Question by Dave C | Product code: 23-4912

14th February 2012

Qif its 2 wire how can it be used as a 2 way switch

AHi this is what the manufacturer datasheet states. The datasheet can be viewed by clicking on the pdf icon.

Question by Bernard | Product code: 23-4912

25th January 2012

Q1. You state 8m range adjustable. Down to, say, 5M ? 2. Suitable for external use ?

AHi Bernard, thanks for your question. According to the manufacturer this is not suitable for outdoor use.

Question by Paul

9th January 2012

QLight switch with motion sensor PIR - 23-4912 If I have the sensor set to go off after 50 seconds but decide to stay in the room for longer, how can i overide this setting without resetting the switch, is there a switch that I can flick like a normal switch to override the 50 sec timeout and then turn off again when i exit the room?

AHi Paul, thanks for your question. Unfortunately there is no way to override the switch. Adding another switch will simply disconnect the power to the feed for the PIR sensor. The only option is to extend the run time so it is on for a little longer

Question by Paul Hughes | Product code: 23-4912

31st October 2011

QIs this a 2-wire or 3-wire product 2-wire directly replaces a light switch, 3-wire has to have an additional neutral wire as well

AThanks for the enquiry Paul - This is a 2-wire product.

Submit a Question